Search results

I use a 391 for walked up ( knock about gun) and the odd time for clays....wouldnt be with out it to be honest. there fun to shoot Sent from my SM-G950F using Tapatalk

I'd shoot mostly gun just out of the shoulder. the slower the bird the lower my mount. trap birds and if I want to get rid of a teal fast pre-mount Sent from my SM-N910F using Tapatalk

The shot string is there. but you are right in saying the swing has no influence on shot string......the shot string is length from the fastest pellets to the slowest nothing got to do with how wide you can spread it with a fast swing (impossible) Sent from my SM-N910F using Tapatalk

This is entertaining but I can see both sides and there is truth in what hamster is saying. Trap shooters well any I know shoot off the end of the gun and shooting in such a way comb hight will have a huge impact on where the gun shoots. On a pattern plate locked in like a trap shooter an the...

It's the vertical of the horizontal (cast) so it should have some affect on where the pellets go. But in practice I found when I raise a comb I still hold the gun at the same angle so not much changes apart from my eye hight Sent from my SM-N910F using Tapatalk

Depends on the gun I hate them cause no fibre wad iv ever shot works in my gun. They don't seal well at all. weak breaks lack of recoil and a pop more than a bang.....I'm particularly down on them at them moment cause was forced to use them just last weekend and hated it. If your bore is...

We will agree to disagree Will.....I'd go as far as saying if I could only shoot fibre I wouldn't shoot at all Sent from my SM-N910F using Tapatalk

Night and day of a difference to me I hate fibre wads Sent from my SM-N910F using Tapatalk

Two from two cheddite smart strike, universal trap, eley game, Hull superfast Sent from my SM-N910F using Tapatalk That photo above just taken this morning after re polishing the old pin and re-installing so a tad shorter than original pin and still piercing the cheddite's Sent from my...

It was problematic enuf to stop the inertia trigger setting the second hammer.....dirt from blowback off the pierced primer. Iv fired every other brand shell I have including game loads and it's only the cheddite's..........every bottom barrel and the odd top barrel piercing. I changed the pins...

Cheddite is the only shell iv had this problem with in this gun.....it's been happening a while by the looks of the pins.......shame cause there smart strike is a nice shell (stupid name ) but a nice shell......time to find another brand of shell I think Sent from my SM-N910F using Tapatalk

Any one have any problems with primers being pierced with cheddite shells Sent from my SM-N910F using Tapatalk

It's not the chokes that pattern tight.....it how tight (good) modern cartridges are compared to what was used when them choke charts were relevant Sent from my SM-N910F using Tapatalk

Dt04068w 1590g 32 sporting Sent from my SM-N910F using Tapatalk

My advice would be set the gun up under your shooting eye dim the other eye and go have some fun shooting...forget about gun fit and everything else for now. Save the pennies and book a few hours with ed solomons who understands eyes and gun fit Sent from my SM-N910F using Tapatalk

Read up on eye dominance and gun fit and you will start to understand what your coach is talking about. But in saying that I'd far sooner close or dim one eye and have my other eye looking down the rib than an eye each side of the rib( basically what your coach is advising) Sent from my...

Ds chokes are nuts.....much more open than they should be so you might what to go a little tighter than you think. The only way to know is pattern what you have and see. After market would be more traditional constriction Sent from my SM-N910F using Tapatalk

Just for laughs we walked back from a battue about 10yards a time. to as far as we could go a full 97 yards (range finder) and was very surprised at how consistently it could be broke as for lead it was something like a bus and and bit.......all 3 of us could break 5-6 out of ten and all of us...

Pin piercing the primer? Sent from my SM-N910F using Tapatalk

Gone up a fair bit in price since I got one from them. But whatever the price well worth it the intermittent jamming is very frustrating. Cole's is very helpful to deal with its a simple 2min job...best of luck Sent from my SM-N910F using Tapatalk