New 725 black mid bead issue.

[shredder]

Just finished shooting the esk selection shoot and noticed a couple of times my bead seemed oval. Couldn't quite figure it out but it turns out my mid bead is of centre and when mounted i see the side of the front bead creating an oval in my vision. 

Is it silly to send it back and ask for it to be sorted?

 

[Simonix]

Perhaps just remove it, and forget about it?

re drilling the hole to make it central will screw up the rib now. 

 

[Darkside]

Take it off...

 

[MJJ]

Have you checked to see if the threaded hole is central and its not the bead made on the pish?

 

[CharlesP]

It's a manufacturing fault. It's part of a gun where accuracy may be compromised. It's a gun built for competition.

Not at all silly to take it back.

In fact it would be silly not to.

 

[shredder]

Not sure if it's the bead on the pish or the whole not centred. It's only a month old so I will not be messing about with it. Back it can go and they can sort it out their end.

 

[Les53]

Not sure if it's the bead on the pish or the whole not centred. It's only a month old so I will not be messing about with it. Back it can go and they can sort it out their end.

Yes Chris, send it back mate, it should be in the centre! 

 

[chippy]

I can kind of see the point of a mid bead if you're shooting premounted trap, but for sporting and skeet what's the use? 

 

[shredder]

For what I shoot I could take both beads of and not really have a issue. The issue is it's a 2.5k and it's not right. 

 

[Les53]

For what I shoot I could take both beads of and not really have a issue. The issue is it's a 2.5k and it's not right. 

Yep I'm with you on that!!  :wink:  I've seen some off centre beads before.......BUT......not on a new gun!!!