Technological tweaks hampering good technique ?

Clay, Trap, Skeet Shooting Forum

Help Support Clay, Trap, Skeet Shooting Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
K

Kentskeet

Guest
I've always thought that perfecting a good shooting technique is paramount in clay shooting, I feel it gives you a good chance of being able to tackle most targets and disciplines to an 'okay' standard. When you find the discipline you enjoy the most and want to shoot on a serious basis ie: Sporting / Trap / skeet then you work on perfecting your technique to suit that specific type of shooting, move to a dedicated gun and have it fitted.

As you work your way up through the ranks you definately meet ' walls' that need good outside help and coaching to break through them. When people feel they're shooting to the best of their ability then it's time to get technical to gain them few extra targets, Specially made and fitted stocks, weighted and balanced guns, etc.etc...all the technical gadgets will enhance a solid technique, not solve underlying problems.

Reading a lot of the posts on the forum it seems a lot of people are 'over thinking' clay shooting or getting too technical too quickly, looking for the next gadget to help them along rather than working on perfecting a solid technique with a good instructor/Coach which in theory will move them forward faster than the latest 'bolt on goodie'.

Regardless of your shooting budget it should still be spent wisely and not wasted, with all the latest guns and gadgets you have to still incorporate " Operator Error" and I think a lot of people forget that they are the "operator"and expect the gun and attached gadgets to do all the work.

 
Totally agree with this,

I have only been shooting clays seriously for 5-6 months now, and have no intention of changing my gun/equipment or getting distracted by sparkly must have accessories until I have a few years or under my belt,

Its my intention to shoot as much as possible, seek as much proffesional coaching and guidence as my budget will allow, to then work on the points raised from the coaching.

Most importantly is to just enjoy it......and learn to improve enjoyably.....as I will never be the next Peter Wilson.

 
I'm looking for a choke between 1/4 and 3/8....any ideas?
Take one 3/8 choke, the superdooper cleaning rod advertised on here, a cordless drill and some grinding paste and make your own.................................................. :wink:

 
Last edited by a moderator:
why+worry.jpg
 
Sorry but i'm not sure you can convert to metric as it isn't a division of an inch but a made up scale to give some idea of the outcome of the shot pattern. Also if I lap a 3/8 choke Andy do I need to worry about drill rotation as it may cause shot swirl??? I know rotation of rifleing in a barrell affectsrate of bullet drop in a cross wind :wink:

 
Roll up some kitchen towel use that superdooper cleaning rod, cordless drill, some finer grade grinding paste and polish the swirls.

Simples....... :) :D :D

 
If you lap a 3/8 choke out you will be going the wrong direction. I think your time would be better spent starting with a full choke and progressively opening it up micron by micron shooting ten cartridges per micron and once you have got to true cylinder evaluating the results, writing a paper on the subject and getting it published then putting back into the bore any metal that was removed by mistake as proven in your theoretical paper.

Right that's him sorted!

Next question, please.

 
1/4=4/16

3/8=6/16 how do i get to 5/16 if lapping out 3/8 is going the wrong way as i want to open the choke up.(make the hole bigger)

 
Last edited by a moderator:
Back
Top